气动剪板机的全技术措施呢主要有以下10点：
第一点呢是当剪板机的间隙小于等于6mm的时候呢，就不需要安装安全防护装置了。
第二点呢是剪板机应该有单次循环的模式，选择单次循环模式后，即使控制装置持续有效，那刀架和压料装置也只能工作一个行程，第3点呢是压料装置应确保剪切钳将剪切材料压紧，压紧后呢板料在剪切时不能移动，
第4点安装在刀架上的刀片呢应该固定可靠，不能仅靠摩擦安装固定，
第5点剪板机上的所有紧固件应紧固，并应采取防松脱的措施，以免引起伤害，
第6点呢是在使用剪板机的时候，剪板机后部落料危险区一般的应该设置阻挡装置，以防止人员发生危险，
第7点应根据剪板机自身的结构性能特点设置格式的安全监督控制装置，对机器的安全运行状况进行监控，
第8点剪板机上呢必须设置紧急停止按钮，一般呢应在剪板机的前面和后面分别进行设置，
第9点如果剪板机配有激光器来指示剪切线，应符合安全标准的相关规定，以确保不是对人身造成伤害，
第10点复位装置呢应该放置在可以清楚观察危险区域的位置，每一个检测区域严禁安装多个复位装置，如果后面由光电保护装置进行防护，每个检测区域呢应安装一个复位装置。
以上呢就是剪板机的相关安全技术要求了。
The full technical measures for pneumatic shearing machines mainly include the following 10 points:
The first point is that when the gap between the shearing machine is less than or equal to 6mm, there is no need to install safety protection devices.
The second point is that the shearing machine should have a single cycle mode. After selecting the single cycle mode, even if the control device is continuously effective, the knife holder and the pressing device can only work for one stroke. The third point is that the pressing device should ensure that the shearing pliers press the shearing material tightly, and after pressing, the sheet material cannot move during shearing,
The blade installed on the tool holder should be securely fixed and not solely fixed by friction,
All fasteners on the shearing machine should be tightened and anti loosening measures should be taken to avoid injury,
The sixth point is that when using a shearing machine, a blocking device should generally be installed in the danger zone of material falling behind the shearing machine to prevent personnel from being in danger,
Point 7: Safety supervision and control devices should be set up according to the structural performance characteristics of the shearing machine itself to monitor the safe operation of the machine,
The eighth point is that an emergency stop button must be installed on the shearing machine, which should generally be set separately in front and behind the shearing machine,
If the shearing machine is equipped with a laser to indicate the cutting line, it should comply with relevant safety standards to ensure that it does not cause harm to personnel,
The reset device should be placed in a position where the danger area can be clearly observed. It is strictly prohibited to install multiple reset devices in each detection area. If it is protected by a photoelectric protection device later, a reset device should be installed in each detection area.
The above are the relevant safety technical requirements for the shearing machine.
|
