机械气动剪板机到货之后怎样使用？
第一步接入380V三相电 l1 l2 l3 接入三根火线，先按我们看一下电机是否为正转，顺时针为正转，如果是反转，调节这三根线中的其中两根，我们平常说的叫换项，直到电机顺时针转。
然后再看一下怎样加油，这个的盖子加入黄油，这个地方加入机械油。这是摇把和数字显示。摇把锁不紧的情况，咱现在来看一下。如果被这个卡住了之后，我们可以把它拉出来之后回去再次向下，直到左右两边是一样的。
下面加注黄油，上面加注机械油，可以参照这个加油铭牌。这个地方也是加注机械油的，所有润滑的组件在到的时候都可以加速一下机械油，
我们现在来踩一下这个踏板试一下。踩一次就是单次运作，如果你踩着不动的话，它就会连续剪切。好了这就是全部的使用了。
How to use the mechanical pneumatic shearing machine after it arrives?
The first step is to connect the 380V three-phase power L1, L2, and L3 to three live wires. First, check if the motor is rotating in the forward direction. Clockwise rotation is positive. If it is in the reverse direction, adjust two of these three wires. This is commonly referred to as switching until the motor rotates clockwise.
Then let's take a look at how to refuel. Add butter to this lid and mechanical oil to this area. This is a handle and digital display. Let's take a look at the situation where the handle is not locked tightly. If it gets stuck, we can pull it out and go back down again until the left and right sides are the same.
Add butter below and mechanical oil above, refer to this refueling label. This place is also filled with mechanical oil, and all lubricated components can be accelerated with mechanical oil when they arrive,
Let's step on this pedal now and try it out. Stepping on it once is a single operation, and if you don't step on it, it will cut continuously. Alright, that's all for use.
|
|
